DVS Atomix LT Guia do Utilizador descarregar pdf (Página 175)

Viz Engine Administrator’s Guide

2. Expand the Matrox Audio/Video devices node, and select the Matrox Bus device.

3. Right-click the Matrox Bus device and select Uninstall.

4. Click OK to confirm the device removal.

5. When the removal is done restart the machine for the changes to take effect.

Warning: This procedure is only necessary if there are problems with the board

and you are unable to remove or update the driver.

To verify the installation using Matrox X.info

1. Right-click the Matrox system tray icon, and select Open X.info.

2. From the Display Information About drop-list, select System to verify that the

correct driver version was installed.

IMPORTANT! Always disable the Allow hibernation when available option.

3. From the Display Information About drop-list, select Hardware, and then the

X.mio2 Plus tab to verify the following:

• Some boards may not have an on-board compositor. See Hardware Information

and check that Installed Options list Compositor as this verifies that the board

is taking advantage of the on-board compositor. X.mio2 Plus has an on-board

compositor even though this is not listed.

• See PCI Bus Info and verify that the board was put into a PCIe slot operating at

the right frequency.

• See Hardware Model (e.g. X.mio2 + 8500) to check for Supported Codecs.

1 2 ... 170 171 172 173 174 175 176 177 178 179 180 ... 339 340

Sem comentários

DVS Atomix LT Guia do Utilizador Página 175